CHNWK - ELMER'S DRYWALL AND PANEL ADHESIVE, E801

  • MSDS: CHNWK
  • Manufacturer: BORDEN INC
  • Product Name: ELMER'S DRYWALL AND PANEL ADHESIVE, E801
  • National Stock Number: 8040-00N088087
Product Identification

Product ID:ELMER'S DRYWALL AND PANEL ADHESIVE, E801
MSDS Date:11/15/1993
FSC:8040
NIIN:00N088087
MSDS Number: CHNWK

Responsible Party
BORDEN INC
180 EAST BROAD ST
COLUMBUS, OH 43215
US

Emergency Phone: 614-431-6600

Info Phone: 614-431-6680

Cage: 07982

Contractor
BORDEN INC
208 COLUMBUS, OH 43215-3705 US

Telephone: 614-225-6124

Cage: 07982

Ingredients

ETHANOL

CAS: 64-17-5

RTECS: KQ6300000

Fraction By Weight: 1-5%

OSHA PEL 1000 PPM

ACGIH TLV: 1000 PPM


KAOLIN

CAS: 1332-58-7

RTECS: GF1670500

Fraction By Weight: 10-30%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 2 MG/M3 TDUST

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:RISK OF DMG & EFTS DEPEND UPON
DURATION & LEVEL OF EXPOS. SKIN ABSORPTION/INGEST/INHAL:NOT TOX
DERMALLY, ORALLY/BY INHAL WHEN TESTED AS DESCRIBED IN 16 CFR PART
1500.3 (C) (1) & (2). INHAL:NOT EXPECTE D TO BE HARMFUL UNDER NORM
CNDTNS OF USE. HOWEVER, OVEREXP MAY CAUSE CNS DEPRESS, ALSO, IF
ALLOWED TO (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:BECOME AIRBORNE, MAY CAUSE IRRIT OF
NOSE, THROAT & LUNGS. SKIN:MAY CAUSE IRRIT ON PRLNG/RPTD CONT. NOT
PRIMARY IRRIT (PRIMARY SKIN IRRIT INDEX <5.0/8.0) WHEN TESTED AS
DESCRIBED IN 16 CFR PAR T 1500.41. EYES:NOT IRRIT WHEN TESTED AS
DESCRIBED IN 16 CFR PART 100.42. ETHANOL:INGEST MAY CAUSE LIVER
DMG. (SUPDAT)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:INGEST:DILUTE BY DRINKING LARGE QUANTITIES OF WATER.
IMMEDIATELY CONTACT POISON CONTROL CENTER OR HOSPITAL EMERGENCY
ROOM FOR ANY OTHER ADDITIONAL TREATMENT DIRECTIONS. INHAL:REMOVE TO
FRESH AIR. SKIN :FLUSH W/WATER. EYES:IMMEDIATELY FLUSH W/PLENTY OF
WATER FOR AT LEAST 15 MINUTES. CALL MD IF IRRITATION PERSISTS.

Fire Fighting

Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE . WILL NOT BURN
UNLESS WATER HAS EVAPORATED.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . IN CASE OF FIRE, WATER SHOULD BE USED TO KEEP
FIRE-EXPOSED CONTAINERS COOL.
Unusual Fire/Explosion Hazard:NONE SPECIFIED BY MANUFACTURER.

Accidental Release

Spill Release Procedures:SWEEP (SCOOP) UP & REMOVE TO A CHEMICAL
DISPOSAL AREA. PREVENT ENTRY INTO NATURAL BODIES OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:KEEP FROM FREEZING. STORE IN A COOL,
DRY PLACE. KEEP CONTAINERS TIGHTLY CLOSED. AVOID PROLONGED OR
REPEATED BREATHING OF VAPOR.
Other Precautions:PERSONS W/SENSITIVE SKIN SHOULD AVOID PRLNG,
CONTINUOUS CONT W/SKIN. IF IRRIT DEVELS, DISCONTINUE USE. HANDLE
I/A/W GOOD SFTY PRACTICES. THESE PRACTICES INCL AVOIDING UNNEC
EXPOS & REMOVAL OF MATL FRO M EYES, SKIN & CLTHG. INSTRUCT (SUPDAT)

Exposure Controls

Respiratory Protection:WHERE AIR CONTAMS CAN EXCEED ACCEPT CRITERIA,
USE NIOSH APPRVD RESP PROT EQUIP. RESPS SHOULD BE SELECTED BASED ON
FORM & CONC & CONTAMS IN AIR I/A/W OSHA 29 CFR 1910.134/OTHER
APPLIC STDS OR GUIDELINE S.
Ventilation:IF AIRBORNE CONTAMS ARE GENERATED WHEN MATL IS
HEATED/HNDLD, SUFFICIENT VENT IN VOL & AIR FLOW PATTERNS SHOULD
(SUPDAT)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:HANDLE I/A/W GOOD INDUSTRIAL HYGIENE PRACTICES.
WASH THOROUGHLY AFTER HANDLING.
Supplemental Safety and Health
PH:4.8 @ 25C. EFTS OF OVEREXP:CAN CAUSE CNS DEPRESS. SIGNS & SYMPS MAY
INCL HDCH, DIZZ, NAUS, VOMIT & DROW. OTHER PREC:YOUR WORKERS TO
HANDLE THIS PROD PROPERLY. BEFORE USING/HANDLING, READ & UNDERSTA
ND THE MSDS. VENT:BE PROVIDED TO KEEP AIR CONTAMINANT CONCENTRATION
LEVELS BELOW ACCEPTABLE CRITERIA.

Chemical Properties

Boiling Pt:B.P. Text:212F,100C
Melt/Freeze Pt:M.P/F.P Text:32.0F,0.0C
Vapor Pres:17 @ 20C
Vapor Density:<1
Spec Gravity:1.17
pH:SUPDAT
Evaporation Rate & Reference:<1 (BUTYL ACETATE=1)
Solubility in Water:DISPERSIBLE
Appearance and Odor:OFF-WHITE PASTE; MILD SOLVENT AROMA.
Percent Volatiles by Volume:39.5

Stability

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS & ALKALINE MATERIALS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:DECOMPOSITION PRODUCTS MAY INCLUDE:
CO, CO*2.

Disposal

Waste Disposal Methods:DISPOSE OF ACCORDING TO LOCAL STATE/PROVINCIAL &
FEDERAL REQUIREMENTS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.